Dell MXL 10GbE - Show Ip Ospf Database Summary

Related
Commands
show ip ospf database — displays OSPF database information.
show ip ospf database summary
Display the network summary (type 3) LSA routing information.
Syntax
show ip ospf process-id database summary [link-state-id] [adv-
router ip-address]
Parameters
process-id Enter the OSPF process ID to show a specific process. If you
do not enter a process ID, the command applies only to the
first OSPF process.
link-state-id (OPTIONAL) Specify LSA ID in dotted decimal format. The
LSA ID value depends on the LSA type, and it can be one of
the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4
LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router ip-
address
(OPTIONAL) Enter the keywords adv-router then the IP
address of an Advertising Router to display only the LSA
information about that router.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip ospf process-id database summary
command shown in the following example.
Item Description
LS Age Displays the LSA age.
Options Displays the optional capabilities available on router. The
following options can be found in this item:
• TOS-capability or No TOS-capability is displayed
depending on whether the router can support Type of
Service.
• DC or No DC is displayed depending on whether the
originating router can support OSPF over demand
circuits.
968
Open Shortest Path First (OSPFv2 and OSPFv3)