Dell MXL 10GbE - Maximum-Paths

Parameters
process-id
Enter the process identification number. The range is from 1
to 65535.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
maximum-paths
Enable the software to forward packets over multiple paths.
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, use the no maximum-paths
command.
Parameters
number Specify the number of paths. The range is from 1 to 64. The
default is 8 paths.
Defaults 4
Command
Modes
ROUTER OSPF for OSPFv3
Command
History
Version 9.2(0.0) Added support for OSPFv3.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
passive-interface
Disable (suppress) sending routing updates on an interface.
Syntax
passive—interface {default | interface}
To enable sending routing updates on an interface, use the no passive-
interface
interface command.
To return all OSPF interfaces (current and future) to active, use the no passive-
interface default command.
996
Open Shortest Path First (OSPFv2 and OSPFv3)