Dell MXL 10GbE - Member

Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You must first enable DEI for this configuration to take effect.
Related
Commands
dei enable — enables DEI.
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack
compatible
command in its configuration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabyte Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
Defaults Not configured.
Command
Modes
conf-if-vl-<vlan-id>-stack
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You must enable the stackable VLAN (using the vlan-stack compatible
command) on the VLAN prior to adding a member to the VLAN.
Related
Commands
vlan-stack compatible — enables stackable VLAN on a VLAN.
1324
VLAN Stacking