Dell MXL 10GbE - Bgp Bestpath Med Missing-As-Best

bgp bestpath med missing-as-best
During path selection, indicate a preference to paths with missing MED (MULTI_EXIT_DISC) over those
paths with an advertised MED attribute.
Syntax
bgp bestpath med missing-as-best
To return to the default selection, use the no bgp bestpath med missing-as-
best command.
Defaults Disabled.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The MED is a 4-byte unsigned integer value and the default behavior is to assume a
missing MED as 4294967295. This command causes a missing MED to be treated
as 0. During path selection, paths with a lower MED are preferred over those with a
higher MED.
bgp client-to-client reflection
Allows you to enable route reflection between clients in a cluster.
Syntax
bgp client-to-client reflection
To disable client-to-client reflection, use the no bgp client-to-client
reflection command.
Defaults Enabled when a route reflector is configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Route reflection to clients is not necessary if all client routers are fully meshed.
Related
Commands
bgp cluster-id — assigns and ID to a BGP cluster with two or more route reflectors.
neighbor route-reflector-client — configures a route reflector and clients.
IPv6 Border Gateway Protocol (IPv6 BGP)
697