Dell MXL 10GbE - Neighbor Add-Path

Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-
name
(OPTIONAL) Enter the name of the peer group.
activate Enter the keyword activate to enable the neighbor/peer
group in the new AFI/SAFI.
Defaults Disabled
Command
Modes
CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
By default, when you create a neighbor/peer group configuration in the Router
BGP context, this enables IPv4/Unicast AFI/SAFI. When you use activate in the
new context, the neighbor/peer group enables for AFI/SAFI.
neighbor add-path
This command allows the specified neighbor/peer group to send/receive multiple path advertisements.
Syntax
neighbor [ip-address | peer-group-name] add-path [send |
receive | both] count
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-
name
(OPTIONAL) Enter the name of the peer group.
send Enter the keyword send to indicate that the system sends
multiple paths to peers.
receive Enter the keyword receive to indicate that the system
accepts multiple paths from peers.
both Enter the keyword both to indicate that the system sends
and accepts multiple paths from peers.
count Enter the number paths supported. The range is from 2 to
64.
Defaults none
Command
Modes
CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
338
Border Gateway Protocol IPv4 (BGPv4)