Dell MXL 10GbE - Default Logging Monitor

default logging monitor
Return to the default settings for messages logged to the terminal.
Syntax
default logging monitor
Defaults level = 7 or debugging
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
logging monitor — sets the logging monitor parameters.
terminal monitor — sends system messages to the terminal/monitor.
default logging trap
Return to the default settings for logging messages to the Syslog servers.
Syntax
default logging trap
Defaults level = 6 or informational
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
logging trap — limit messages logged to the Syslog servers based on severity.
logging
Configure an IP address or host name of a Syslog server where logging messages are sent. You can
configure multiple logging servers of both IPv4 and/or IPv6.
Syntax
logging {ip-address | ipv6–address |hostname} {{udp {port}} |
{tcp {port}}
To disable logging, use the no logging command.
Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
1242
Simple Network Management Protocol (SNMP) and Syslog