Dell MXL 10GbE - 15 Equal Cost Multi-Path (ECMP)

15
Equal Cost Multi-Path (ECMP)
Equal cost multi-path (ECMP) is supported on the Dell Networking MXL 10/40GbE Switch IO Module.
ecmp-group
Provides a mechanism to monitor traffic distribution on an ECMP link bundle. A system log is generated
when the standard deviation of traffic distribution on a member link exceeds a defined threshold.
Syntax
ecmp-group {ecmp-group-id interface interface | link-bundle-
monitor}
To remove the selected interface, use the ecmp-group no interface
command.
To disable link bundle monitoring, use the ecmp-group no link-bundle-
monitor command.
Parameters
ecmp-group ID Enter the identifier number for the ECMP group. The range is
from 2 to 64.
interface Enter the following keywords and slot/port to add the
interface to the ECMP group:
• 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information
link-bundle-
monitor
Enter the keywords link-bundle-monitor to enable link
bundle monitoring.
Defaults Off
Command
Modes
• CONFIGURATION
• CONFIGURATION ECMP-GROUP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Equal Cost Multi-Path (ECMP)
503