Dell MXL 10GbE - Show Config

Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You must have an IP address assigned to an interface to enter ROUTER OSPF mode
and configure OSPF.
Example
Dell(conf)#router ospf 2
Dell(conf-router_ospf)#
show config
Display the non-default values in the current OSPF configuration.
Syntax
show config
Command
Modes
ROUTER OSPF
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
Dell(conf-router_ospf)#
show ip ospf
Display information on the OSPF process configured on the switch.
Syntax
show ip ospf process-id
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
952
Open Shortest Path First (OSPFv2 and OSPFv3)