Hardware Commands
These commands display information from a hardware sub-component or ASIC.
clear hardware stack-unit
Clear statistics from selected hardware components.
Syntax
clear hardware stack-unit 0–5 {counters | unit 0–1 counters |
cpu data-plane statistics | cpu party-bus statistics | stack-
port 0–52}
Parameters
stack-unit 0–5 Enter the keywords stack-unit then 0 to 5 to select a
particular stack member and then enter one of the following
command options to clear a specific collection of data.
counters Enter the keyword counters to clear the counters on the
selected stack member.
unit 0–0
counters
Enter the keyword unit along with a port-pipe number,
from 0 to 1, then the keyword counters to clear the
counters on the selected port-pipe.
cpu data-plane
statistics
Enter the keywords cpu data-plane statistics to clear
the data plane statistics.
cpu party-bus
statistics
Enter the keywords cpu party-bus statistics to clear
the management statistics.
stack-port 33–
56
Enter the keywords stack-port then the port number of
the stacking port to clear the statistics of the particular
stacking port. The range is from 33 to 56.
NOTE: You can identify stack port numbers by physical
inspection of the rear modules. The numbering is the
same as for the 10G ports. You can also inspect the
output of the show system stack-ports command.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
show hardware stack-unit — displays the data plane or management plane input
and output statistics of the designated component of the designated stack
member.
472
Debugging and Diagnostics
To Next Page
Loading...
