Dell MXL 10GbE - Show Ip Pim Snooping Neighbor

Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip pim snooping interface commands
shown in the following example.
Field Description
Interface Displays the VLAN interfaces with PIM-SM snooping
enabled.
Ver/Mode Displays the PIM version number for each VLAN interface
with PIM-SM snooping enabled:
• v2 = PIM version 2
• S = PIM Sparse mode
Nbr Count Displays the number of neighbors learned through PIM-SM
snooping on the interface.
DR Prio Displays the Designated Router priority value configured on
the interface (ip pim dr-priority command).
DR Displays the IP address of the Designated Router for that
interface.
Example (#2)
Dell#show ip pim snooping interface
Interface Ver Nbr DR DR
Count Prio
Vlan 2 v2 3 1 165.87.32.2
show ip pim snooping neighbor
Display information on PIM neighbors learned through PIM-SM snooping.
Syntax
show ip pim snooping neighbor [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display information about
PIM neighbors that PIM-SM snooping discovered on a
specified VLAN. The valid VLAN IDs range is from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
PIM-Sparse Mode (PIM-SM)
1027