Dell MXL 10GbE - Upgrade Boot

Lines Beginning
With
Description
Chassis Type: Chassis type (for example, E1200, E600, E600i, E300, C300,
C150, S25, S50, S55, S60, S4810)
Control
Processor:...
Control processor information and amount of memory on
processor
128K bytes... Amount and type of memory on system
1 34 Port Hardware configuration of the system, including the
number and type of physical interfaces available
upgrade boot
Upgrade the bootflash image or bootselector image.
Syntax
upgrade boot {all | bootflash-image | bootselector-image}
stack-unit {0-5 | all} {booted | flash: |ftp: | tftp: |
usbflash:} (A: | B:}
Parameters
all Enter the keyword all to change both the bootflash and
bootselecter images.
bootflash-
image
Enter the keywords bootflash-image to change the
bootflash image.
bootselector-
image
Enter the keywords bootselector-image to change the
bootselector image.
0–5 Enter the keyword 0–5 to upgrade all stack-units.
all Enter the keyword all to upgrade all the member stack-
units.
booted Enter the keyword booted to upgrade from the current
image in the MXL 10/40GbE Switch.
ftp: After entering the keyword ftp:, you can either follow it
with the location of the source file in this form:
//
userid:password@hostip/filepath or press Enter to
launch a prompt sequence.
tftp: After entering the keyword tftp:, you can either follow it
with the location of the source file in this form:
//
hostlocation/filepath or press Enter to launch a
prompt sequence.
flash: After entering the keyword flash:, you can either follow it
with the location of the source file in this form:
//filepath
or press Enter to launch a prompt sequence.
74
File Management