interface vlan — configures a VLAN interface.
show config (from INTERFACE RANGE mode) — shows the bulk configuration
interfaces.
show range — shows the bulk configuration ranges.
interface range macro (define)
Defines a macro for an interface range and then saves the macro in the running configuration.
Syntax
define interface range macro name interface , interface , ...
Parameters
name Enter up to 16 characters for the macro name.
interface,
interface,...
Enter the keywords interface range and one of the
interfaces — slot/port, port-channel, or VLAN number. Select
the range of interfaces for bulk configuration. You can enter
up to six comma-separated ranges. Spaces are not required
between the commas. Comma-separated ranges can
include VLANs, port-channels, and physical interfaces.
Slot/Port information must contain a space before and after
the dash. For example, interface range
gigabitethernet 0/1 - 5
is valid; interface range
gigabitethernet 0/1-5 is NOT valid.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Interfaces
567
To Next Page
Loading...
