The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Usage
Information
To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version
command in configuration mode. By default, the system log version is set to 0.
The following describes the two supported log messages formats:
• 0 – Displays syslog messages format as described in RFC 3164, The BSD syslog
Protocol
• 1 – Displays SYSLOG message format as described in RFC 5424, The Syslog
Protocol
Example
Dell(conf)#logging version ?
<0-1> Select syslog version (default = 0)
Dell(conf)#logging version 1
show logging
Display the logging settings and system messages logged to the internal buffer of the switch.
Syntax
show logging [number | history [reverse][number] | reverse
[number] | summary]
Parameters
number (OPTIONAL) Enter the number of messages displayed in the
output. The range is from 1 to 65535.
history (OPTIONAL) Enter the keyword history to view only
information in the Syslog history table.
reverse (OPTIONAL) Enter the keyword reverse to view the Syslog
messages in FIFO (first in, first out) order.
summary (OPTIONAL) Enter the keyword summary to view a table
showing the number of messages per type and per slot. Slots
*7* and *8* represent RPMs.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
(Partial)
Dell#show logging
Syslog logging: enabled
Console logging: level debugging
Monitor logging: level debugging
Buffer logging: level debugging, 311 Messages Logged, Size
Simple Network Management Protocol (SNMP) and Syslog
1251
To Next Page
Loading...
Need help?
General
