Dell MXL 10GbE - Show Ip Udp-Helper

Defaults none
Command
Modes
INTERFACE (config-if)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you configure the ip helper-address command and ip udp-helper udp-
port command, the behavior is that the UDP broadcast traffic with port numbers
67/68 is unicast relayed to the DHCP server per the ip helper-address
configuration. This occurs regardless if the ip udp-helper udp-port command
contains port numbers 67/68 or not.
If you only configure the ip udp-helper udp-port command, all the UDP
broadcast traffic is flooded, including ports 67/68 traffic if those ports are part of
the
udp-port-list.
Related
Commands
ip helper-address — configures the destination broadcast or host address for the
DHCP server.
debug ip udp-helper — enables debug and displays the debug information on a
console.
show ip udp-helper — displays the configured UDP helpers on all interfaces.
show ip udp-helper
Display the configured UDP helpers on all interfaces.
Syntax
show ip udp-helper
Defaults none
Command
Modes
EXEC
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show ip udp-helper
--------------------------------------------------
Port UDP port list
--------------------------------------------------
Gi 10/0 656, 658
Gi 10/1 All
Related
Commands
debug ip udp-helper — enables debug and displays the debug information on a
console.
ip udp-broadcast-address — configures a UDP IP address for broadcast.
Interfaces
611