Dell MXL 10GbE - Description

description
Configure a short text string describing the VRRP group.
Syntax
description text
To delete a VRRP group description, use the no description command.
Parameters
text Enter a text string up to 80 characters long.
Defaults Not enabled.
Command
Modes
VRRP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
disable
Disable a VRRP group.
Syntax
disable
To re-enable a disabled VRRP group, use the no disable command.
Defaults Enabled.
Command
Modes
VRRP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To enable VRRP traffic, assign an IP address to the VRRP group using the
virtual-address command and enter no disable.
Related
Commands
virtual-address — specifies the IP address of the virtual router.
hold-time
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the
initialization of the VRRP MASTER, the new switch can stabilize its routing tables.
Syntax
hold-time {seconds | centisecs centisecs}
To return to the default value, use the no hold-time command.
1348
Virtual Router Redundancy Protocol (VRRP)