Dell MXL 10GbE - Track Ip

Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults All interfaces in Layer 2 mode are untagged.
Command
Modes
INTERFACE VLAN
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you use the no tagged command, the interface is automatically placed in
the Default VLAN as an untagged interface unless the interface is a member of
another VLAN. If the interface belongs to several VLANs, remove it from all VLANs
to change it to an untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can
only belong to one VLAN at a time.
In programmable-mux (PMUX) mode of input/output aggregator (IOA), when you
use the no tagged command on an interface, the VLAN is not removed from the
VLAN table, even if there are no active members for the VLAN.
Related
Commands
interface vlan — configures a VLAN.
untagged — specifies which interfaces in a VLAN are untagged.
track ip
Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member interfaces.
Syntax
track ip interface
To remove the tracking feature from the VLAN, use the no track ip interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
862
Layer 2