22
IPv4 Routing
The basic IPv4 commands are supported by Dell Networking Operating System (OS).
arp
To associate an IP address with a multicast MAC address in the switch when you configure multicast
mode of the network load balancing (NLB), use the address resolution protocol (ARP).
Syntax
arp ip-address multicast-mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
ip-address Enter an IP address in dotted decimal format.
multicast-mac-
address
Enter a 48–bit hexadecimal address in MAC address in
nn:nn:nn:nn:nn:nn format for the static MAC address to be
used to switch multicast traffic..
interface (OPTIONAL) Enter any of the following keywords and slot/
port or number information:
• For the Management interface, enter the keyword
ManagementEthernet then the slot/port information.
The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• The interface specified here must be one of the
interfaces configured using the {output-range |
output}
interface option with the mac-address-
table static command.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.3(0.0) Added the support for association of an IP address with
multicast MAC address on the MXL platform.
IPv4 Routing
613
To Next Page
Loading...
