Dell MXL 10GbE - Ip Pim Join-Filter

ip pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command
prevents the PIM-SM router from creating state based on multicast source and/or group.
Syntax
ip pim join-filter ext-access-list {in | out}
To remove the access list, use the no ip pim join-filter ext-access-list
{in | out} command.
Parameters
ext-access-list Enter the name of an extended access list.
in Enter this keyword to apply the access list to inbound traffic.
out Enter this keyword to apply the access list to outbound
traffic.
Defaults none
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf)# ip access-list extended iptv-channels
Dell(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
Dell(config-ext-nacl)# permit ip any 232.1.1.0/24
Dell(config-ext-nacl)# permit ip 100.1.1.0/16 any
Dell(config-if-gi-1/1)# ip pim join-filter iptv-channels in
Dell(config-if-gi-1/1)# ip pim join-filter iptv-channels out
Related
Commands
ip access-list extended — configure an access list based on IP addresses or
protocols.
ip pim ingress-interface-map
When the Dell Networking system is the RP, statically map potential incoming interfaces to (*,G) entries
to create a lossless multicast forwarding environment.
Syntax
ip pim ingress-interface-map std-access-list
Parameters
std-access-list Enter the name of a standard access list.
Defaults none
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
PIM-Sparse Mode (PIM-SM)
1017