Dell MXL 10GbE - Banner Motd

'c' is a delimiting
character
Dell(conf)#no banner login ?
keyboard-interactive Prompt will be displayed by default
<cr>
Dell(conf)#banner login keyboard-interactive
Enter TEXT message. End with the character '%'.
This is the banner%
Dell(conf)#end
Dell#exit
13d21h9m: %STKUNIT0-M:CP %SEC-5-LOGOUT: Exec session is
terminated for user on
line console
This is the banner
Dell Force10 con0 now available
Press RETURN to get started.
13d21h10m: STKUNIT0-M:CP %SEC-5-LOGIN_SUCCESS: Login
successful for user on line
console
This is the banner
Related
Commands
banner motd — sets a Message of the Day banner.
exec-banner — enables the display of a text string when you enter EXEC mode.
banner motd
Set a message of the day (MOTD) banner.
Syntax
banner motd c line c
Parameters
c Enter a delineator character to specify the limits of the text
banner. The delineator is a percent character (%).
line Enter a text string for your message of the day banner
message ending the message with your delineator. The
delineator is a percent character (%).
Defaults No banner is configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
A MOTD banner message displays only in EXEC Privilege mode after entering the
enable command then the password. These banners do not display to users in
EXEC (non-privilege) mode.
Control and Monitoring
81