The range is from 0 to 40000000. The default granularity is
Megabits per second (Mbps).
committed-
rate
Enter the bandwidth in Mbps. The range is from 0 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16
to 200000. The default is 100.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to
specify the peak rate in Mbps. The range is from 0 to 10000.
The default is the same as designated for committed-rate.
Defaults Burst size is 100 KB. peak-rate is the same as committed-rate. Granularity for
committed-rate and peak-rate is Mbps unless you use the kbps option.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
rate police — specifies traffic policing on the selected interface.
qos-policy-input — creates a QoS output policy.
rate shape
Shape the traffic output on the selected interface.
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). Make the following value a multiple of 64.
The range is from 0 to 40000000. The default granularity is
Megabits per second (Mbps).
rate Enter the outgoing rate in multiples of 10 Mbps. The range is
from 10 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 0 to
10000. The default is 50.
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command
Modes
QOS-POLICY-OUT
1092
Quality of Service (QoS)
To Next Page
Loading...
