Dell MXL 10GbE - Neighbor Peer-Group (Creating Group)

Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You can assign up to 64 peers to one peer group.
When you add a peer to a peer group, it inherits all the peer group’s configured
parameters. A peer cannot become part of a peer group if any of the following
commands are configured on the peer:
• neighbor advertisement-interval
• neighbor distribute-list
• neighbor filter-list
• neighbor next-hop-self
• neighbor route-map
• neighbor route-reflector-client
• neighbor send-community
A neighbor may keep its configuration after it was added to a peer group if the
neighbor’s configuration is more specific than the peer group’s and the neighbor’s
configuration does not affect outgoing updates.
A peer group must exist before you add a peer to it. If the peer group is disabled
(shutdown) the peers within the group are also disabled (shutdown).
Related
Commands
capture bgp-pdu max-buffer-size — resets BGP sessions.
neighbor peer-group (creating group) — creates a peer group.
show ip bgp ipv6 unicast peer-group — views BGP peers.
show ip bgp ipv6 unicast neighbors — views BGP neighbors configurations.
neighbor peer-group (creating group)
Allows you to create a peer group and assign it a name.
Syntax
neighbor peer-group-name peer-group
To delete a peer group, use the no neighbor peer-group-name peer-group
command.
Parameters
peer-group-
name
Enter a text string up to 16 characters long as the name of
the peer group.
Defaults Not configured.
730
IPv6 Border Gateway Protocol (IPv6 BGP)