Dell MXL 10GbE - Snmp-Server Location

snmp-server enable command and the snmp-server host command for that
host must be enabled.
NOTE: For v1 / v2c trap configuration, if the community-string is not defined
using the snmp-server community command prior to using this command,
the default form of the
snmp-server community command automatically is
configured with the community-name the same as specified in the snmp-
server host
command.
Configuring Informs
To send an inform, use the following steps:
1. Configure a remote engine ID.
2. Configure a remote user.
3. Configure a group for this user with access rights.
4. Enable traps.
5. Configure a host to receive informs.
Related
Commands
snmp-server enable traps — enables SNMP traps.
snmp-server community — configures a new community SNMPv1 or SNMPv2c.
snmp-server location
Configure the location of the SNMP server.
Syntax
snmp-server location text
To delete the SNMP location, use the no snmp-server location command.
Parameters
text Enter an alpha-numeric text string, up to 55 characters long.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Simple Network Management Protocol (SNMP) and Syslog
1233