show cam pbr
Display the PBR CAM content.
Syntax
show cam pbr {[interface interface] | stack—unit slot-number
port-set number]} [summary]
Parameters
interface
interface
Enter the keyword interface then the name of the
interface.
stack–unit
number
Enter the keyword stack-unit then the slot number. The
range is from 0 to 11 .
port-set
number
Enter the keywords port-set then the port-pipe number.
The range is from 0 to 1.
summary Enter the keyword summary to view only the total number of
CAM entries.
Defaults none
Command
Modes
EXEC
Command
History
Version 9.4(0.0) Added support for removing the Sonet interface on the MXL
10/40GbE Switch IO Module.
Version 7.4.1.0 Introduced.
Usage
Information
The show cam pbr command displays the PBR CAM content.
Example
Dell#show cam pbr stack-unit 0 po 0
TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST,
Bit 1 - SYN, Bit 0 - FIN
Cam Port VlanID Proto Tcp Src Dst
SrcIp
DstIp Next-hop Egress
Index Flag Port
Port
MAC Port
---------------------------------------------------------------
---------------------------------------------------------------
------------
00000 5 N/A IP 0x0 0 0
22.22.2.22/32
33.33.3.0/24 00:01:e8:8a:fd:76 0/0
00001 5 N/A 145 0x0 0 0
0.0.0.0/0
44.4.4.4/32 00:01:e8:8a:fd:76 Vl 100(0/1)
00002 5 N/A TCP 0x0 0 0
55.1.3.0/24
66.6.6.6/32 00:01:e8:8a:fd:76 Po 128
00003 5 N/A UDP 0x0 0 0
55.1.3.0/24
66.6.6.6/32 00:01:e8:8a:fd:76 Po 128
00004 5 N/A IP 0x0 0 0
Policy-based Routing (PBR)
1011
To Next Page
Loading...
