Usage
Information
NOTE: Per port rate police is supported for Layer 2 tagged and untagged
switched traffic and for Layer 3 traffic. Per VLAN rate police is supported on
only tagged ports with Layer 2 switched traffic.
On one interface, you can configure the rate police command for a VLAN or
you can configure the rate police command for an interface. For each physical
interface, you can configure three
rate police commands specifying different
VLANS.
For each physical interface, you can configure three rate police commands
specifying different VLANs.
Related
Commands
rate-police — specifies traffic policing on the selected interface.
rate shape
Shape the traffic output on the selected interface.
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). Make the following value a multiple of 64.
The range is from 0 to 40000000. The default granularity is
Megabits per second (Mbps).
rate Enter the outgoing rate in multiples of 10 Mbps. The range is
from 10 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 0 to
10000. The default is 50.
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
rate-shape — shapes traffic output as part of the designated policy.
Quality of Service (QoS)
1075
To Next Page
Loading...
