Dell MXL 10GbE - Multicast

35
Multicast
The multicast commands are supported by Dell Networking Operating System (OS).
This chapter contains the following sections:
• IPv4 Multicast Commands
• IPv6 Multicast Commands
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent
multicast (PIM) tree information base, use the clear ip pim tib command.
Syntax
clear ip mroute {group-address [source-address] | * | snooping}
Parameters
group-address
[source-
address]
Enter the multicast group address and source address (if
desired), in dotted decimal format, to clear information on a
specific group.
* Enter * to clear all multicast routes.
snooping Enter the keyword snooping to delete multicast snooping
route table entries.
Command
Modes
EXEC Privilege
Command
History
Version 9.2.
(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
show ip pim tib — shows the PIM tree information base.
912
Multicast