Dell MXL 10GbE - Advertise Med Voice

show running-config lldp — displays the LLDP running configuration.
advertise med voice
To advertise a dedicated IP telephony handset or other appliances supporting interactive voice services,
configure the system.
Syntax
advertise med voice {vlan-id} | {priority-tagged number}
To return to the default, use the no advertise med voice {vlan-id} |
{priority-tagged
number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
priority-tagged
number
Enter the keywords priority-tagged then the Layer 2
priority. The range is from 0 to 7.
Defaults unconfigured.
Command
Modes
CONFIGURATION (conf-lldp)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
advertise med voice-signaling
To advertise when voice control packets use a separate network policy than voice data, configure the
system.
Syntax
advertise med voice-signaling {vlan-id} | {priority-tagged
number}
To return to the default, use the no advertise med voice-signaling
{vlan-id} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
priority-tagged
number
Enter the keywords priority-tagged then the Layer 2
priority. The range is from 0 to 7.
880
Link Layer Discovery Protocol (LLDP)