Dell MXL 10GbE - Rmon Event

Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
rmon event
Add an event in the RMON event table.
Syntax
rmon event number [log] [trap community] [description string]
[owner name]
To disable RMON on an interface, use the no rmon event number command.
Parameters
number Assign an event number in integer format from 1 to 65535.
The number value must be unique in the RMON event table.
log (OPTIONAL) Enter the keyword log to generate an RMON
log entry. The log entry is triggered and sets the eventType in
the RMON MIB to log or log-and-trap. The default is No log.
trap
community
(OPTIONAL) Enter the keyword trap then an SNMP
community string to configure the eventType setting in the
RMON MIB. This keyword sets either snmp-trap or log-and-
trap. The default is public.
description
string
(OPTIONAL) Enter the keyword description then a string
describing the event.
owner name (OPTIONAL) Enter the keyword owner then the name of the
owner of this event.
Defaults As noted in the Parameters section.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
rmon hc-alarm
Set an alarm on any MIB object.
Syntax
rmon hc-alarm number variable interval {delta | absolute}
rising-threshold value event-number falling-threshold value
event-number [owner string]
To disable the alarm, use the no rmon hc-alarm number command.
Remote Monitoring (RMON)
1133