Dell MXL 10GbE - Show Config

Parameters
session-ID Enter a session identification number. The range is from 0 to
65535.
type rpm |
erpm
Specifies one of the following type:
• rpm: to create remote port monitoring session.
• erpm: to create encapsulated remote port monitoring
session.
• If no option is specified, by default SPAN will be created.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0) Added support for rpm / erpm.
Version 8.3.16.1 Introduced on the M I/O Aggregator.
Usage
Information
The monitor command is saved in the running configuration at Monitor Session
mode level and can be restored after a chassis reload.
Example
Dell(conf)# monitor session 60
Dell(conf-mon-sess-60)
Related
Command
show monitor session — displays the monitor session.
show running-config monitor session — displays the running configuration of a
monitor session.
show config
Display the current monitor session configuration.
Syntax
show config
Defaults none
Command
Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
Version 8.3.16.1 Introduced on the M I/O Aggregator.
Example
Dell(conf-mon-sess-1)#show config
!
monitor session 1
source TenGigabitEthernet 0/1 destination Port-channel 1
direction rx
1046
Port Monitoring