Dell MXL 10GbE - Show Dcb

• priority-list — configures the 802.1p priorities.
show dcb
Displays the data center bridging status, the number of PFC-enabled ports, and the number of PFC-
enabled queues.
Syntax
show dcb [stack-unit unit-number]
Parameters
unit number Enter the DCB unit number. The range is from 0 to 5.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Specify a stack-unit number on the Master switch in a stack.
Example
Dell(conf)#do show dcb
stack-unit 0 port-set 0
DCB Status :Enabled
PFC Queue Count :2
Total Buffer[lossy + lossless] (in KB):7982
PFC Total Buffer (in KB) :5872
PFC Shared Buffer (in KB) :832
PFC Available Buffer (in KB) :4860
Dell (conf)#
show interface dcbx detail
Displays the DCBX configuration on an interface.
Syntax
show interface port-type slot/port dcbx detail
Parameters
port-type Enter the port type.
slot/port Enter the slot/port number.
Command
Modes
CONFIGURATION
440
Data Center Bridging (DCB)