Dell MXL 10GbE - Show Ip Bgp Next-Hop

D 70.70.23.0/24 100.10.10.2 0 0 100 200 ?
D 70.70.24.0/24 100.10.10.2 0 0 100 200 ?
Dell#
Related
Commands
show ip bgp — views the current BGP routing table.
show ip bgp next-hop
View all next hops (using learned routes only) with current reachability and flap status. This command
only displays one path, even if the next hop is reachable by multiple paths.
Syntax
show ip bgp next-hop
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip bgp next-hop command shown in the
following example.
Field Description
Next-hop Displays the next-hop IP address.
Via Displays the IP address and interface used to reach the next
hop.
RefCount Displays the number of BGP routes using this next hop.
Cost Displays the cost associated with using this next hop.
Flaps Displays the number of times the next hop has flapped.
Time Elapsed Displays the time elapsed since the next hop was learned. If
the route is down, this field displays time elapsed since the
route went down.
Example
Dell>show ip bgp next-hop
Next-hop Via RefCount Cost Flaps Time
Elapsed
63.114.8.33 63.114.8.33, Gi 12/22 240984 0 0 00:18:25
63.114.8.34 63.114.8.34, Gi 12/22 135152 0 0 00:18:13
63.114.8.35 63.114.8.35, Gi 12/22 1 0 0 00:18:07
63.114.8.60 63.114.8.60, Gi 12/22 135155 0 0 00:18:11
Dell>
Border Gateway Protocol IPv4 (BGPv4)
381