• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ntp trusted-key
Set a key to authenticate the system to which NTP synchronizes.
Syntax
ntp trusted-key number
To delete the key, use the no ntp trusted-key number command.
Parameters
number Enter a number as the trusted key ID. The range is from 1 to
4294967295.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The number parameter in the ntp trusted-key command must be the same
number as the number parameter in the ntp authentication-key command. If
you change the ntp authentication-key command, you must also change the
ntp trusted-key command.
Related
Commands
ntp authentication-key — sets an authentication key for NTP.
ntp authenticate — enables the NTP authentication parameters you set.
ntp update-calendar
Configure the system to update the calendar (the hardware clock) with the NTP-derived time.
Syntax
ntp update-calendar [minutes]
To return to default setting, use the no ntp update-calendar command.
System Time and Date
1291
To Next Page
Loading...
