exec-timeout
Set a time interval that the system waits for input on a line before disconnecting the session.
Syntax
exec-timeout minutes [seconds]
To return to default settings, use the no exec-timeout command.
Parameters
minutes Enter the number of minutes of inactivity on the system
before disconnecting the current session. The range is from
0 to 35791. The default is
10 minutes for the console line
and 30 minutes for the VTY line.
seconds (OPTIONAL) Enter the number of seconds. The range is from
0 to 2147483. The default is 0 seconds.
Defaults 10 minutes for console line; 30 minutes for VTY lines; 0 seconds
Command
Modes
LINE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To remove the time interval, use the exec-timeout 0 0 command.
Example
Dell con0 is now available
Press RETURN to get started.
Dell>
exit
Return to the lower command mode.
Syntax
exit
Command
Modes
• EXEC Privilege
• CONFIGURATION
• LINE
• INTERFACE
• PROTOCOL GVRP
• SPANNING TREE
• MULTIPLE SPANNING TREE
• MAC ACCESS LIST
• ACCESS-LIST
• PREFIX-LIST
• ROUTER OSPF
88
Control and Monitoring
To Next Page
Loading...
