Dell MXL 10GbE - Ip Split-Horizon

Usage
Information
To enable the interface to send both version of RIP packets, use the ip rip send
version 1 2 command.
Related
Commands
ip rip receive version — sets the RIP version for the interface to receive traffic.
version — sets the RIP version for the switch software.
ip split-horizon
Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme
prevents any routes learned over a specific interface to be sent back out that interface.
Syntax
ip split-horizon
To disable split-horizon, use the no ip split-horizon command.
Defaults Enabled
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
ip poison-reverse — sets the prefix for RIP routing updates.
maximum-paths
Set RIP to forward packets over multiple paths.
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths commands.
Parameters
number Enter the number of paths. The range is from 1 to 16. The
default is 4 paths.
Defaults 4
Command
Modes
ROUTER RIP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
1120
Routing Information Protocol (RIP)