Dell MXL 10GbE - Radius-Server Retransmit

Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The key configured on the switch must match the key configured on the RADIUS
server daemon.
If you configure the key parameter in the radius-server host command, the
key configured with the
radius-server key command is the default key for all
RADIUS communications.
Related
Commands
radius-server host — configures a RADIUS host.
radius-server retransmit
Configure the number of times the switch attempts to connect with the configured RADIUS host server
before declaring the RADIUS host server unreachable.
Syntax
radius-server retransmit retries
To configure zero retransmit attempts, use the no radius-server retransmit
command.
To return to the default setting, use the radius-server retransmit 3
command.
Parameters
retries Enter a number of attempts that the system tries to locate a
RADIUS server. The range is from zero (0) to 100. The default
is 3 retries.
Defaults 3 retries
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
radius-server host — configures a RADIUS host.
1178
Security