Dell MXL 10GbE - Clear Ip Msdp Statistic

local Enter the keyword local to clear out local PIM advertised
entries. It applies the redistribute filter (if present) while
adding the local PIM SA entries to the SA cache.
Defaults Without any options, this command clears the entire source-active cache.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
clear ip msdp statistic
Clears the entire source-active cache, the source-active entries of a particular multicast group, rejected,
or local source-active entries.
Syntax
clear ip msdp sa-cache [group-address | rejected-sa | local]
Parameters
group-address Enter the group IP address in dotted decimal format
(A.B.C.D.).
rejected-sa Enter the keyword rejected-sa to clear the cache source-
active entries that are rejected because the RPF check failed,
an SA filter or limit is configured, the RP or MSDP peer is
unreachable, or because of a format error.
local Enter the keyword local to clear out local PIM advertised
entries. It applies the redistribute filter (if present) while
adding the local PIM SA entries to the SA cache.
Defaults Without any options, this command clears the entire source-active cache.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
debug ip msdp
Turn on MSDP debugging.
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address |
packet peer address | pim} command.
888
Multicast Source Discovery Protocol (MSDP)