Dell MXL 10GbE - Redistribute

Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Though the system does not generate a route due to backdoor config, there is an
option for injecting/ sourcing a local route in presence of network backdoor config
on a learned route.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static}
command.
Parameters
connected Enter the keyword connected to redistribute routes from
physically connected interfaces.
static Enter the keyword static to redistribute manually
configured routes. These routes are treated as incomplete
routes.
route-map
map-name
(OPTIONAL) Enter the keywords route-map then the name
of an established route map.
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you do not configure the default-metric command, in addition to the
redistribute command, or there is no route map to set the metric, the metric
for redistributed static and connected is “0”.
To redistribute the default route (0::0/0), configure the neighbor default-
originate
command.
Related
Commands
neighbor default-originate — injects the default route.
IPv6 Border Gateway Protocol (IPv6 BGP)
741