Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
• reload — reboots the system.
• show system — displays the current status of all stack members or a specific
member.
• show system stack-unit stack-group displays the stack-groups present/
configured for a MXL 10/40GbE switch stack unit
stack-unit priority
Configure the ability of an MXL 10/40GbE switch to become the management unit of a stack.
Syntax
stack-unit 0–5 priority 1-14
Parameters
0–5 Enter the stack member unit identifier, from 0 to 5, of the
switch on which you want to set the management priority.
1–14 This preference parameter allows you to specify the
management priority of one backup switch over another,
with 1 the lowest priority and 14 the highest.
The switch with the highest priority value will be chosen to
become the management unit.
Defaults 0
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
• reload — reboots the system.
• show system — displays the status of all stack members or a specific member.
Stacking
1261
To Next Page
Loading...
