Dell MXL 10GbE - Show Ip Interface

Field Description
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is
listed.
EC Displays the number of ECMP paths.
Example
Dell#show ip fib stack-unit 0
Destination Gateway First-Hop Mac-Addr
Port VId EC
---------------------------------------------------------------
--------
10.10.10.10/32 Direct, Nu 0 0.0.0.0 00:00:00:00:00:00 BLK
HOLE 0 0
Dell>
Related
Commands
clear ip fib stack-unit — clear FIB entries on a specified stack-unit.
show ip interface
View IP-related information on all interfaces.
Syntax
show ip interface [interface | brief] [configured]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Loopback interface, enter the keyword Loopback
then a number from 0 to 16383.
• For the Management interface, enter the keyword
ManagementEthernet then zero (0).
• For the Null interface, enter the keyword null then zero
(0).
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a brief
summary of the interfaces and whether an IP address is
assigned.
configured (OPTIONAL) Enter the keyword configured to display the
physical interfaces with non-default configurations only.
IPv4 Routing
643