Dell MXL 10GbE - Enable

do
Allows the execution of most EXEC-level commands from all CONFIGURATION levels without returning
to the EXEC level.
Syntax
do command
Parameters
command Enter an EXEC-level command.
Defaults none
Command
Modes
• CONFIGURATION
• INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following commands are not supported by the do command:
• enable
• disable
• exit
• config
Example
Dell(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
Dell(conf-if-te-5/0)#
Dell(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
Dell(conf-if-te-5/0)#
Dell(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
Dell(conf-if-te-5/0)#
enable
Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may
need to enter a password.
Syntax
enable [level]
Parameters
level (OPTIONAL) Enter a number for a privilege level of the Dell
Networking OS. The range is from 0 to 15. The default is 15.
Defaults 15
Control and Monitoring
85