Dell MXL 10GbE - Debug Vrrp

Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
debug vrrp
Allows you to enable debugging of VRRP.
Syntax
debug vrrp interface [vrrp-id] {all | packets | state | timer}
To disable debugging, use the no debug vrrp interface [vrrp-id] {all |
packets | state | timer}
command.
Parameters
interface Enter the following keywords and slot/port or number
information
• For Port Channel interface types, enter the keywords
port-channel then the number. The range is from 1 to
128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
vrrp-id (OPTIONAL) Enter a number from 1 to 255 as the VRRP
group ID.
all Enter the keyword all to enable debugging of all VRRP
groups.
packets Enter the keyword packets to enable debugging of VRRP
control packets.
state Enter the keyword state to enable debugging of VRRP state
changes.
timer Enter the keyword timer to enable debugging of the VRRP
timer.
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you do not specify options, debug is active on all interfaces and all VRRP groups.
Virtual Router Redundancy Protocol (VRRP)
1347