Dell MXL 10GbE - Qos-Policy-Input

Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To assign traffic to different flows using QoS policy, use the Output Policy map.
This command enables Policy-Map-Output Configuration mode (conf-policy-
map-out).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS
using policy maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-input
Create a QoS input policy on the router.
Syntax
qos-policy-input qos-policy-name [layer2]
To remove an existing input QoS policy from the router, use the no qos-policy-
input
qos-policy-name [layer2] command.
Parameters
qos-policy-
name
Enter the name for the policy map in character format (32
characters maximum).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2
Class Map. The default is Layer 3.
Defaults Layer 3
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To specify the name of the input QoS policy, use this command. After the input
policy is specified, rate-police is defined. This command enables Qos-Policy-Input
Configuration mode — (conf-qos-policy-in).
1090
Quality of Service (QoS)