Dell MXL 10GbE - Clear Lldp Counters

Parameters
system-
capabilities
Enter the keywords system-capabilities to advertise the
system capabilities TLVs to the LLDP peer.
system-
description
Enter the keywords system-description to advertise the
system description TLVs to the LLDP peer.
system-name Enter the keywords system-name to advertise the system
name TLVs to the LLDP peer.
Defaults none
Command
Modes
CONFIGURATION (conf-lldp)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The command options system-capabilities, system-description, and
system-name can be invoked individually or together, in any sequence.
clear lldp counters
Clear LLDP transmitting and receiving counters for all physical interfaces or a specific physical interface.
Syntax
clear lldp counters interface
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1497