Dell MXL 10GbE - PFC Commands

------------------------------------------------
0 0,1,2,3,4,5,6,7 100% ETS
1 - -
2 - -
3 - -
4 - -
5 - -
6 - -
7 - -
8 - -
Stack unit 1 stack port all
Max Supported TC Groups is 4
Number of Traffic Classes is 1
Admin mode is on
Admin Parameters:
--------------------
Admin is enabled
TC-grp Priority# Bandwidth TSA
------------------------------------------------
0 0,1,2,3,4,5,6,7 100% ETS
1 - -
2 - -
3 - -
4 - -
5 - -
6 - -
7 - -
8 - -
PFC Commands
The following PFC commands are supported on the FC Flex IO module installed in the MXL 10/40GbE
Switch platform.
clear pfc counters
Clear the PFC TLV counters and PFC statistics on an interface or stack unit.
Syntax
clear pfc counters [port-type slot/port | stack-unit {unit
number | all } all stack-ports all}] | interface {statistics}]
Parameters
port-type Enter the keywords port-type then the slot/port
information.
stack-unit unit
number
Enter the keywords stack-unit then the stack-unit number
to be cleared.
all stack-ports
all
Enter the keywords all stack-ports all to clear the
counters on all interfaces.
statistics Enter the keyword statistics to clear only the hardware
PFC counters.
Defaults none
FC Flex IO Modules
1395