Dell MXL 10GbE - Show Ip Ospf Routes

show ip ospf routes
Display routes OSPF calculates and stores in OSPF RIB.
Syntax
show ip ospf process-id routes
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command is useful in isolating routing problems between the OSPF and the
RTM. For example, if a route is missing from the RTM/FIB but is visible from the
display output of this command, the problem is with downloading the route to the
RTM.
This command has the following limitations:
• The display output is sorted by prefixes; intra-area ECMP routes are not
displayed together.
• For Type 2 external routes, Type 1 cost is not displayed.
Example
Dell#show ip ospf 100 route
Prefix Cost Nexthop Interface Area Type
1.1.1.1 1 0.0.0.0 Lo 0 0 Intra-Area
3.3.3.3 2 13.0.0.3 Gi 0/47 1 Intra-Area
13.0.0.0 1 0.0.0.0 Gi 0/47 0 Intra-Area
150.150.150.0 2 13.0.0.3 Gi 0/47 - External
172.30.1.0 2 13.0.0.3 Gi 0/47 1 Intra-Area
Dell#
show ip ospf statistics
Display OSPF statistics.
Syntax
show ip ospf process-id statistics global | [interface name
{neighbor router-id}]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Open Shortest Path First (OSPFv2 and OSPFv3)
973