Dell MXL 10GbE - Lacp Long-Timeout

events (OPTIONAL) Enter the keyword events to debug the LACP
event information.
pdu (OPTIONAL) Enter the keyword pdu to debug the LACP
Protocol Data Unit information.
interface in |
out
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Optionally, enter an in or out parameter:
• Receive enter in
• Transmit enter out
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-
timeout command.
Defaults 1 second
Command
Modes
INTERFACE (conf-if-po-number)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command applies to dynamic port-channel interfaces only. When applied on a
static port-channel, this command has no effect.
Link Aggregation Control Protocol (LACP)
841