Dell MXL 10GbE - Protocol-Tunnel

• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
in | out | both Enter the keyword in, out, or both to debug incoming
interfaces, outgoing interfaces, or both incoming and
outgoing interfaces.
vlan vlan-id Enter the keyword vlan then the VLAN ID. The range is from
1 to 4094.
count value Enter the keyword count then the number of debug
outputs. The range is from 1 to 100.
Defaults Debug disabled.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
protocol-tunnel
Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.
Syntax
protocol-tunnel {rate-limit rate| stp}
To disable protocol tunneling for a Layer 2 protocol, use the no protocol-
tunnel
command.
Parameters
rate-limit rate Enter the keyword rate-limit then a number for the rate-
limit for tunneled packets on the VMAN. The range is from
64 to 320.
stp Enter the keyword stp to enable protocol tunneling on a
spanning tree, including STP, MSTP, RSTP, and PVST.
Defaults none
Command
Modes
CONF-IF-VLAN
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#conf
Dell(conf)#interface vlan 2
Dell(conf-if-vl-2)#vlan-stack compatible
Dell(conf-if-vl-2)#member Gi1/2-3
Dell(conf-if-vl-2)#protocol-tunnel stp
Dell(conf-if-vl-2)#protocol-tunnel enable
Service Provider Bridging
1217