Dell MXL 10GbE - Disable

Parameters
config Enter the keyword config to enable debugging on the
GVRP configuration.
event Enter the keyword event to enable debugging on the JOIN/
LEAVE events.
pdu Enter the keyword pdu then one of the following Interface
keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults Disabled.
Command
Modes
EXEC
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
disable
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults Enabled.
Command
Modes
CONFIGURATION-GVRP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
gvrp enable — enables GVRP on physical interfaces and LAGs.
protocol gvrp — access GVRP protocol.
GARP VLAN Registration (GVRP)
537