Parameters
vlan vlan-id Enter the keyword vlan and then the ID of the VLAN. The
range is from 1 to 4094.
Defaults none
Command
Modes
CONF-CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0) Introduced on the MXL switch.
Usage
Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VLAN ID .
Related
Commands
class-map — identifies the class map.
match ip vrf
Uses a VRF as the match criterion for an L3 class map.
Syntax
match ip vrf vrf-id
To remove VRF as the match criterion, use the no match ip vrf vrf-id
command.
Parameters
vlan vlan-id Enter the keyword vrf and then the ID of the VRF. The range
is from 1 to 63.
Defaults none
Command
Modes
CONF-CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0) Introduced on the MXL switch.
Usage
Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
Quality of Service (QoS)
1083
To Next Page
Loading...
