Dell MXL 10GbE - Hello

show lldp neighbors — displays the LLDP neighbors.
hello
Configure the rate at which the LLDP control packets are sent to its peer.
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds Enter the rate, in seconds, at which the control packets are
sent to its peer. The rate is from 5 to 180 seconds. The
default is 30 seconds.
Defaults 30 seconds
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
mode
To receive or transmit, set LLDP.
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx Enter the keyword tx to set the mode to transmit.
rx Enter the keyword rx to set the mode to receive.
Defaults Both transmit and receive.
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
870
Link Layer Discovery Protocol (LLDP)