Dell MXL 10GbE - Privilege Level (CONFIGURATION Mode)

Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
privilege level (CONFIGURATION mode)
Change the access or privilege level of one or more commands.
Syntax
privilege mode {level level command | reset command}
To delete access to a level and command, use the no privilege mode level
level command
command.
Parameters
mode Enter one of the following keywords as the mode for which
you are controlling access:
• configure for CONFIGURATION mode
• exec for EXEC mode
• interface for INTERFACE modes
• line for LINE mode
• route-map for ROUTE-MAP mode
• router for ROUTER OSPF, ROUTER RIP, ROUTER ISIS
and ROUTER BGP modes
level level Enter the keyword level then a number for the access level.
The range is from 0 to 15.
Level 1 is EXEC mode and Level 15 allows access to all CLI
modes and commands.
reset Enter the keyword reset to return the security level to the
default setting.
command Enter the command’s keywords to assign the command to a
certain access level. You can enter one or all of the
keywords.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To define a password for the level to which you are assigning privilege or access,
use the enable password command.
1160
Security